Problema com o adaptador PCI TP-Link Wireless TL-WN851ND

1

Instalei um novo Adaptador PCI sem fio, chamado TL-WN851ND no meu PC.

Meu sistema operacional identifica e posso me conectar à minha rede.

Quando tento usar o navegador para navegar na rede, perco a conexão e o adaptador sem fio para de funcionar corretamente.

Alguém pode me dar uma ideia para resolver isso? Eu preciso de uma solução porque não quero instalar o Windows.

Eu postei a saída de alguns comandos:

Obrigado.

lspci -nnk | grep 0280 -A2

04:05.0 Network controller [0280]: Qualcomm Atheros AR9227 Wireless Network Adapter [168c:002d] (rev 01)
   Subsystem: Qualcomm Atheros AR9227 Wireless Network Adapter [168c:0300]
   Kernel driver in use: ath9k

rfkill listar todos

0: phy0: Wireless LAN
   Soft blocked: no
   Hard blocked: no

sudo lshw -C rede

  *-network               
       description: Ethernet interface
       product: VT6102/VT6103 [Rhine-II]
       vendor: VIA Technologies, Inc.
       physical id: 12
       bus info: pci@0000:00:12.0
       logical name: enp0s18
       version: 7c
       serial: 00:1d:60:22:df:27
       size: 100Mbit/s
       capacity: 100Mbit/s
       width: 32 bits
       clock: 33MHz
       capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=via-rhine driverversion=1.5.1 duplex=full ip=192.168.1.107 latency=64 link=yes maxlatency=8 mingnt=3 multicast=yes port=MII speed=100Mbit/s
       resources: irq:23 ioport:c000(size=256) memory:fbcff800-fbcff8ff
  *-network
       description: Wireless interface
       product: AR9227 Wireless Network Adapter
       vendor: Qualcomm Atheros
       physical id: 5
       bus info: pci@0000:04:05.0
       logical name: wlp4s5
       version: 01
       serial: 98:de:d0:8c:07:54
       width: 32 bits
       clock: 66MHz
       capabilities: bus_master cap_list ethernet physical wireless
       configuration: broadcast=yes driver=ath9k driverversion=4.4.0-57-generic firmware=N/A ip=192.168.1.108 latency=168 link=yes multicast=yes wireless=IEEE 802.11bgn
       resources: irq:19 memory:fbef0000-fbefffff

iwconfig

wlp4s5    IEEE 802.11bgn  ESSID:"Rete_2.4GHz"  
          Mode:Managed  Frequency:2.447 GHz  Access Point: 60:E3:27:9A:84:94   
          Bit Rate=1 Mb/s   Tx-Power=19 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=46/70  Signal level=-64 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:101   Missed beacon:0

lo        no wireless extensions.

enp0s18   no wireless extensions.

route -n

Tabella di routing IP del kernel
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         192.168.1.1     0.0.0.0         UG    600    0        0 wlp4s5
192.168.1.0     0.0.0.0         255.255.255.0   U     600    0        0 wlp4s5

cat / etc / network / interfaces

interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback

ping -c 3 8.8.4.4

PING 8.8.4.4 (8.8.4.4) 56(84) bytes of data.
64 bytes from 8.8.4.4: icmp_seq=1 ttl=45 time=62.2 ms
64 bytes from 8.8.4.4: icmp_seq=2 ttl=45 time=61.7 ms
64 bytes from 8.8.4.4: icmp_seq=3 ttl=45 time=61.5 ms

--- 8.8.4.4 ping statistics ---
3 packets transmitted, 3 received, 0% packet loss, time 2001ms
rtt min/avg/max/mdev = 61.546/61.837/62.218/0.347 ms
    
por Diego 27.12.2016 / 22:36

0 respostas