Não é possível montar a unidade USB com a mensagem de erro “tipo errado de fs, má opção, superbloco ruim”

1
NAME   MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT

    lsblk
        sda      8:0    0 931,5G  0 disk 
        ├─sda1   8:1    0   100M  0 part 
        ├─sda2   8:2    0 150,3G  0 part 
        ├─sda3   8:3    0 558,5G  0 part 
        ├─sda4   8:4    0     1K  0 part 
        ├─sda5   8:5    0 220,7G  0 part /
        └─sda6   8:6    0     2G  0 part [SWAP]
        sdb      8:16   1   7,5G  0 disk 
        └─sdb1   8:17   1   7,5G  0 part 
        sr0     11:0    1  1024M  0 rom 

E quando eu tento

 mount /dev/sdb /mnt
mount: wrong fs type, bad option, bad superblock on /dev/sdb,
       missing codepage or helper program, or other error

com dmesg -tail

dmesg | tail
[ 1059.082039] usbcore: registered new interface driver usb-storage
[ 1059.109149] usbcore: registered new interface driver uas
[ 1060.081502] scsi 6:0:0:0: Direct-Access     JetFlash Transcend 8GB    8.07 PQ: 0 ANSI: 4
[ 1060.081841] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 1060.083326] sd 6:0:0:0: [sdb] 15679488 512-byte logical blocks: (8.02 GB/7.47 GiB)
[ 1060.085260] sd 6:0:0:0: [sdb] Write Protect is off
[ 1060.085264] sd 6:0:0:0: [sdb] Mode Sense: 23 00 00 00
[ 1060.086416] sd 6:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[ 1060.092027]  sdb: sdb1
[ 1060.096224] sd 6:0:0:0: [sdb] Attached SCSI removable disk

parted /dev/sdb
GNU Parted 3.2
Using /dev/sdb
Welcome to GNU Parted! Type 'help' to view a list of commands.
(parted) p                                                                
Model: JetFlash Transcend 8GB (scsi)
Disk /dev/sdb: 8028MB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Disk Flags: 

Number  Start  End     Size    Type     File system  Flags
 1      131kB  8028MB  8028MB  primary

Como resolver isso?

    
por MikiBelavista 27.11.2015 / 14:41

1 resposta

4

O drive USB parece estar particionado. Não monte o dispositivo diretamente, mas a partição /dev/sdb1 em vez disso:

mount /dev/sdb1 /mnt
    
por Jens Erat 27.11.2015 / 14:47