Controlador Externo PCIe USB 3.0 NEC Corporation uPD720200 não recocnizado desde a atualização para 14.04

Question

Eu uso uma placa PCIe USB 3.0 externa. Ele costumava funcionar como um encanto em 13.10. Mas desde que a atualização para o 14.04 hot-plug parece não funcionar mais. Ela costumava trabalhar antes.

Somente quando esta placa está conectada, ela está funcionando. dmesg mostra: 03: 00.0 Controlador USB: NEC Corporation Controlador host USB 3.0 uPD720200 (rev 03)

Quando conectado durante a operação, recebo apenas uma mensagem de que ocorreu um evento hot-plug. Além disso, nada acontece.

Alguma ideia do porquê?

Editar 2014-06-14:

Eu tenho pesquisado para cima e para baixo na pasta / var / log.

Parece-me que o kernel não reconhece o cartão durante o hot-plug

inicializar com placa PCIe externa instalada

Comando

lspci:

03:00.0 USB controller: NEC Corporation uPD720200 USB 3.0 Host Controller (rev 03)

/ var / log / dmesg:

[    1.314043] xhci_hcd 0000:03:00.0: xHCI Host Controller
[    1.314049] xhci_hcd 0000:03:00.0: new USB bus registered, assigned bus number 3
[    1.314343] xhci_hcd 0000:03:00.0: irq 42 for MSI/MSI-X
[    1.314350] xhci_hcd 0000:03:00.0: irq 43 for MSI/MSI-X
[    1.314356] xhci_hcd 0000:03:00.0: irq 44 for MSI/MSI-X
[    1.314362] xhci_hcd 0000:03:00.0: irq 45 for MSI/MSI-X
[    1.314369] xhci_hcd 0000:03:00.0: irq 46 for MSI/MSI-X
[    1.314544] usb usb3: New USB device found, idVendor=1d6b, idProduct=0002
[    1.314546] usb usb3: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[    1.314548] usb usb3: Product: xHCI Host Controller
[    1.314549] usb usb3: Manufacturer: Linux 3.13.0-30-generic xhci_hcd
[    1.314551] usb usb3: SerialNumber: 0000:03:00.0
[    1.314658] hub 3-0:1.0: USB hub found
[    1.314672] hub 3-0:1.0: 2 ports detected
[    1.314742] xhci_hcd 0000:03:00.0: xHCI Host Controller
[    1.314746] xhci_hcd 0000:03:00.0: new USB bus registered, assigned bus number 4
[    1.317621] usb usb4: New USB device found, idVendor=1d6b, idProduct=0003
[    1.317622] usb usb4: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[    1.317624] usb usb4: Product: xHCI Host Controller
[    1.317625] usb usb4: Manufacturer: Linux 3.13.0-30-generic xhci_hcd
[    1.317627] usb usb4: SerialNumber: 0000:03:00.0
[    1.317700] hub 4-0:1.0: USB hub found
[    1.317713] hub 4-0:1.0: 2 ports detected

/var/log/sys.log: (mensagem do Kernal ao conectar um disco externo USB 3.o)

Jun 14 15:19:09 marina711 kernel: [  403.002797] usb 4-1: new SuperSpeed USB device number 2 using xhci_hcd
Jun 14 15:19:09 marina711 kernel: [  403.020710] usb 4-1: Parent hub missing LPM exit latency info.  Power management will be impacted.
Jun 14 15:19:09 marina711 kernel: [  403.023650] usb 4-1: New USB device found, idVendor=0480, idProduct=a00d
Jun 14 15:19:09 marina711 kernel: [  403.023661] usb 4-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Jun 14 15:19:09 marina711 kernel: [  403.023667] usb 4-1: Product: External USB 3.0
Jun 14 15:19:09 marina711 kernel: [  403.023672] usb 4-1: Manufacturer: TOSHIBA
Jun 14 15:19:09 marina711 kernel: [  403.023677] usb 4-1: SerialNumber: 23183A26B28E
Jun 14 15:19:09 marina711 mtp-probe: checking bus 4, device 2: "/sys/devices/pci0000:00/0000:00:1c.2/0000:03:00.0/usb4/4-1"
Jun 14 15:19:09 marina711 mtp-probe: bus: 4, device: 2 was not an MTP device
Jun 14 15:19:09 marina711 kernel: [  403.047210] usb-storage 4-1:1.0: USB Mass Storage device detected
Jun 14 15:19:09 marina711 kernel: [  403.047466] scsi6 : usb-storage 4-1:1.0
Jun 14 15:19:09 marina711 kernel: [  403.047575] usbcore: registered new interface driver usb-storage
Jun 14 15:19:13 marina711 kernel: [  406.305836] scsi 6:0:0:0: Direct-Access     TOSHIBA  External USB 3.0 5438 PQ: 0 ANSI: 6
Jun 14 15:19:13 marina711 kernel: [  406.306478] sd 6:0:0:0: Attached scsi generic sg2 type 0
Jun 14 15:19:13 marina711 kernel: [  406.307703] sd 6:0:0:0: [sdc] 1953525164 512-byte logical blocks: (1.00 TB/931 GiB)
Jun 14 15:19:13 marina711 kernel: [  406.308102] sd 6:0:0:0: [sdc] Write Protect is off
Jun 14 15:19:13 marina711 kernel: [  406.308106] sd 6:0:0:0: [sdc] Mode Sense: 23 00 00 00
Jun 14 15:19:13 marina711 kernel: [  406.308805] sd 6:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
Jun 14 15:19:13 marina711 kernel: [  406.317164]  sdc: sdc1
Jun 14 15:19:13 marina711 kernel: [  406.344720] sd 6:0:0:0: [sdc] Attached SCSI disk

/ var / log / udev:

UDEV  [4.174356] add      /devices/pci0000:00/0000:00:1c.2/0000:03:00.0 (pci)
ACTION=add
DEVPATH=/devices/pci0000:00/0000:00:1c.2/0000:03:00.0
DRIVER=xhci_hcd
ID_MODEL_FROM_DATABASE=uPD720200 USB 3.0 Host Controller
ID_PCI_CLASS_FROM_DATABASE=Serial bus controller
ID_PCI_INTERFACE_FROM_DATABASE=XHCI
ID_PCI_SUBCLASS_FROM_DATABASE=USB controller
ID_VENDOR_FROM_DATABASE=NEC Corporation
MODALIAS=pci:v00001033d00000194sv0000FFFFsd0000FFFFbc0Csc03i30
PCI_CLASS=C0330
PCI_ID=1033:0194
PCI_SLOT_NAME=0000:03:00.0
PCI_SUBSYS_ID=FFFF:FFFF
SEQNUM=1666
SUBSYSTEM=pci
USEC_INITIALIZED=85

Mensagens com cartão ligado a quente:

lspci: nada encontrado

/ var / log / dmesg: nada encontrado

comando

dmesg:

[   31.456256] ACPI: \_SB_.PCI0: Bus check notify on hotplug_event_root

/var/log/kern.log: nada encontrado

/var/log/sys.log: nada encontrado

/ var / log / udev: nada foi encontrado

comando dmesg após desconectar:

[  719.603717] ACPI: \_SB_.PCI0: Bus check notify on hotplug_event_root

Comparou os módulos carregados em lsmod para ambos os casos: Nenhuma diferença encontrada

Quando o cartão foi conectado no momento da inicialização, ele aparece no lspci. Quando eu desconecto, então, ainda está lá!