Eu instalei o Kismet na minha máquina Ubuntu 10.04 como o apt-get install kismet tudo parece funcionar bem.
mas quando eu inicio vejo o seguinte erro
kismet
Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to
change channel.
Source 0 (addme): Opening none source interface none...
FATAL: Please configure at least one packet source. Kismet will not
function if no packet sources are defined in kismet.conf or on the
command line. Please read the README for more information about
configuring Kismet.
Kismet exiting.
Done.
Eu segui este guia link
como sempre em kismet.conf Eu não estou claro com a seguinte linha
source=none,none,addme
sobre o que devo mudar isso para.
lspci -vnn mostra
0c:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g [14e4:4315] (rev 01)
Subsystem: Dell Device [1028:000c]
Flags: bus master, fast devsel, latency 0, IRQ 17
Memory at f69fc000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information <?>
Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [13c] Virtual Channel <?>
Capabilities: [160] Device Serial Number
Capabilities: [16c] Power Budgeting <?>
Kernel driver in use: wl
Kernel modules: wl, ssb
e
O iwconfig mostra
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11bg ESSID:"WIKUCD"
Mode:Managed Frequency:2.462 GHz Access Point: <00:43:92:21:H5:09>
Bit Rate=11 Mb/s Tx-Power:24 dBm
Retry min limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Managementmode:All packets received
Link Quality=1/5 Signal level=-81 dBm Noise level=-90 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:169 Invalid misc:0 Missed beacon:0
Então, o que eu deveria estar colocando no lugar de
source=none,none,addme
com saída que mencionei acima?
WL (Linux, Intel)
Broadcom has released a binary version of their drivers called WL.
These drivers are incapable of monitor mode, and cannot be used with
Kismet. Kismet will attempt to autodetect them and report this to the
user. Users of Broadcom cards should use the b43 or b43xx in-kernel
drivers.
Então, tente com
source=bcm4312,none,kbr0
Acho que isso deve funcionar.
Tags linux ubuntu-10.04