Substitua o disco RAID no Supermicro X9SCL / X9SCM após o relatório SMART CurrentPendingSector e OfflineUncorrectableSector

Question

Eu tenho um Supermicro X9SCL / X9SCM com o Ubuntu 14.

Possui 2 RAIDs HARDWARE (Intel SATA RAID Controller) e um disco de um ataque está falhando (da partição primária / de inicialização). O SMART monitor está me avisando por e-mail sobre os erros CurrentPendingSector e OfflineUncorrectableSector .

Recebi o status do relatório SMART e acho que esse é o problema:

197 Current_Pending_Sector  0x0012   100   100   000    Old_age   Always       -       13
198 Offline_Uncorrectable   0x0010   100   100   000    Old_age   Offline      -       13

Estes são os e-mails do SMARTD que informam os resultados do teste todos os dias

>> SMART error (OfflineUncorrectableSector) detected on host: XXXX

This message was generated by the smartd daemon running on:

   host name:  XXXX
   DNS domain: [Empty]

The following warning/error was logged by the smartd daemon:

Device: /dev/sdb [SAT], 13 Offline uncorrectable sectors

Device info:
ST31000524AS, S/N:5VPB80GS, WWN:5-000c50-048d38efe, FW:JC4B, 1.00 TB

For details see host's SYSLOG.

You can also use the smartctl utility for further investigation.
The original message about this issue was sent at Sun Feb  7 21:16:55 2016 BRST
Another message will be sent in 24 hours if the problem persists.

e

SMART error (CurrentPendingSector) detected on host: XXXX

This message was generated by the smartd daemon running on:

   host name:  XXXX
   DNS domain: [Empty]

The following warning/error was logged by the smartd daemon:

Device: /dev/sdb [SAT], 13 Currently unreadable (pending) sectors

Device info:
ST31000524AS, S/N:5VPB80GS, WWN:5-000c50-048d38efe, FW:JC4B, 1.00 TB

For details see host's SYSLOG.

You can also use the smartctl utility for further investigation.
The original message about this issue was sent at Sun Feb  7 21:16:55 2016 BRST
Another message will be sent in 24 hours if the problem persists.

Eu preciso mudar, mas sou novato nisso, e minha pergunta é:

Há algo mais a fazer que apenas altera o disco com falha (desligamento, alteração, energização)?