Eu tenho um laptop Toshiba Satellite P870 no qual a conexão sem fio está funcionando, mas a eth0 não está aparecendo na rede. No entanto, aparece no lspci:
Observe o segundo para a última entrada: Qualcomm Atheros AR8162 Fast Ethernet
steve@mithril:~$ lspci
00:00.0 Host bridge: Intel Corporation 3rd Gen Core processor DRAM Controller (rev 09)
00:02.0 VGA compatible controller: Intel Corporation 3rd Gen Core processor Graphics Controller (rev 09)
00:14.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB xHCI Host Controller (rev 04)
00:16.0 Communication controller: Intel Corporation 7 Series/C210 Series Chipset Family MEI Controller #1 (rev 04)
00:1a.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB Enhanced Host Controller #2 (rev 04)
00:1b.0 Audio device: Intel Corporation 7 Series/C210 Series Chipset Family High Definition Audio Controller (rev 04)
00:1c.0 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 1 (rev c4)
00:1c.1 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 2 (rev c4)
00:1c.4 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 5 (rev c4)
00:1d.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB Enhanced Host Controller #1 (rev 04)
00:1f.0 ISA bridge: Intel Corporation HM76 Express Chipset LPC Controller (rev 04)
00:1f.2 SATA controller: Intel Corporation 7 Series Chipset Family 6-port SATA Controller [AHCI mode] (rev 04)
00:1f.3 SMBus: Intel Corporation 7 Series/C210 Series Chipset Family SMBus Controller (rev 04)
01:00.0 Ethernet controller: Qualcomm Atheros AR8162 Fast Ethernet (rev 10)
02:00.0 Network controller: Intel Corporation Centrino Wireless-N 2230 (rev c4)
03:00.0 Unassigned class [ff00]: Realtek Semiconductor Co., Ltd. RTS5229 PCI Express Card Reader (rev 01)
Mas a eth0 não está aparecendo
steve@mithril:~$ ifconfig -a
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:26500 errors:0 dropped:0 overruns:0 frame:0
TX packets:26500 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2380423 (2.3 MB) TX bytes:2380423 (2.3 MB)
wlan0 Link encap:Ethernet HWaddr 60:36:dd:9c:24:35
inet addr:10.0.0.31 Bcast:10.0.0.255 Mask:255.255.255.0
inet6 addr: 2601:9:7680:6bd:35da:dd37:2c59:f693/64 Scope:Global
inet6 addr: 2601:9:7680:6bd:6236:ddff:fe9c:2435/64 Scope:Global
inet6 addr: fe80::6236:ddff:fe9c:2435/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:437201 errors:0 dropped:0 overruns:0 frame:0
TX packets:200898 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:560417483 (560.4 MB) TX bytes:154418423 (154.4 MB)
Aqui está o arquivo / etc / network / interfaces
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet dhcp
Aqui está lshw -C network :
steve@mithril:~$ sudo lshw -C network
*-network UNCLAIMED
description: Ethernet controller
product: AR8162 Fast Ethernet
vendor: Qualcomm Atheros
physical id: 0
bus info: pci@0000:01:00.0
version: 10
width: 64 bits
clock: 33MHz
capabilities: pm pciexpress msi msix bus_master cap_list
configuration: latency=0
resources: memory:c8600000-c863ffff ioport:2000(size=128)
*-network
description: Wireless interface
product: Centrino Wireless-N 2230
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:02:00.0
logical name: wlan0
version: c4
serial: 60:36:dd:9c:24:35
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=iwlwifi driverversion=3.2.0-65-generic firmware=18.168.6.1 ip=10.0.0.31 latency=0 link=yes multicast=yes wireless=IEEE 802.11bgn
resources: irq:43 memory:c8500000-c8501fff
UPDATE De tentar a correção de @guyfleeman
steve@mithril:/shared/compat-drivers-2013-03-04-u$ ./scripts/driver-select alx
Processing new driver-select request...
steve@mithril:/shared/compat-drivers-2013-03-04-u$ make
./scripts/gen-compat-autoconf.sh /shared/compat-drivers-2013-03-04-u/.config /shared/compat-drivers-2013-03-04-u/config.mk > include/linux/compat_autoconf.h
make -C /lib/modules/3.2.0-65-generic/build M=/shared/compat-drivers-2013-03-04-u modules
make[1]: Entering directory '/usr/src/linux-headers-3.2.0-65-generic'
CC [M] /shared/compat-drivers-2013-03-04-u/compat/main.o
In file included from /shared/compat-drivers-2013-03-04-u/include/linux/compat-2.6.h:67:0,
from <command-line>:0:
/shared/compat-drivers-2013-03-04-u/include/linux/compat-3.4.h:43:21: error: redefinition of ‘kmalloc_array’
include/linux/slab.h:243:21: note: previous definition of ‘kmalloc_array’ was here
In file included from /shared/compat-drivers-2013-03-04-u/include/linux/compat-2.6.h:71:0,
from <command-line>:0:
/shared/compat-drivers-2013-03-04-u/include/linux/compat-3.8.h:49:32: error: redefinition of ‘kref_get_unless_zero’
include/linux/kref.h:47:32: note: previous definition of ‘kref_get_unless_zero’ was here
make[3]: *** [/shared/compat-drivers-2013-03-04-u/compat/main.o] Error 1
make[2]: *** [/shared/compat-drivers-2013-03-04-u/compat] Error 2
make[1]: *** [_module_/shared/compat-drivers-2013-03-04-u] Error 2
make[1]: Leaving directory '/usr/src/linux-headers-3.2.0-65-generic'
make: *** [modules] Error 2