Estou montando um túnel com uma empresa de telecomunicações usando AWS / VPC / EC2 / Centos7 / Libreswan e estou preso há semanas. Aprecie qualquer ajuda!
Eu tenho 192.168.16.73 (VPN GW, EIP 52.76.x.x) e 192.168.16.116 (Servidor de Domínio de Criptografia). O túnel parece estar ativo, mas não pode receber nenhuma resposta de ping. Eu acho que o tráfego de ping não está passando pelo túnel.
Eu fiz estes.
1. Desativar verificação de origem / destino na VPN GW
2. Na minha tabela de rotas VPC, adicionei Target = VPN GW para o destino 192.100.86.0/24
tcpdump -n icmp (enquanto faz o ping de 192.168.16.116 para 192.100.86.69)
tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on eth0, link-type EN10MB (Ethernet), capture size 65535 bytes
17:32:04.926003 IP 192.168.16.116 > 192.100.86.69: ICMP echo request, id 22412, seq 9593, length 64
17:32:04.926029 IP 52.76.x.x > 192.100.86.69: ICMP echo request, id 22412, seq 9593, length 64
17:32:05.186064 IP 192.168.16.116 > 192.100.86.69: ICMP echo request, id 23423, seq 6789, length 64
17:32:05.186092 IP 52.76.x.x > 192.100.86.69: ICMP echo request, id 23423, seq 6789, length 64
porta 500 do tcpdump ou porta 4500
0 packets captured
0 packets received by filter
0 packets dropped by kernel
status do ipsec
000 "telco":
192.168.16.116/32===192.168.16.73[52.76.x.x]---192.168.16.1...203.92.y.y<203.92.y.y>===192.100.86.0/24; erouted; eroute owner: #2
000 "telco": oriented; my_ip=192.168.16.116; their_ip=unset
000 "telco": xauth info: us:none, them:none, my_xauthuser=[any]; their_xauthuser=[any]
000 "telco": modecfg info: us:none, them:none, modecfg policy:push, dns1:unset, dns2:unset, domain:unset, banner:unset;
000 "telco": labeled_ipsec:no;
000 "telco": policy_label:unset;
000 "telco": ike_life: 86400s; ipsec_life: 3600s; rekey_margin: 540s; rekey_fuzz: 100%; keyingtries: 0;
000 "telco": retransmit-interval: 500ms; retransmit-timeout: 60s;
000 "telco": sha2_truncbug:no; initial_contact:no; cisco_unity:no; send_vendorid:no;
000 "telco": policy: PSK+ENCRYPT+TUNNEL+UP+IKEV1_ALLOW+IKEV2_ALLOW+SAREF_TRACK+IKE_FRAG_ALLOW;
000 "telco": conn_prio: 32,24; interface: eth0; metric: 0; mtu: unset; sa_prio:auto; nflog-group: unset;
000 "telco": dpd: action:hold; delay:0; timeout:0; nat-t: force_encaps:yes; nat_keepalive:yes; ikev1_natt:both
000 "telco": newest ISAKMP SA: #1; newest IPsec SA: #2;
000 "telco": IKE algorithms wanted: 3DES_CBC(5)_000-MD5(1)_000-MODP1024(2)
000 "telco": IKE algorithms found: 3DES_CBC(5)_192-MD5(1)_128-MODP1024(2)
000 "telco": IKE algorithm newest: 3DES_CBC_192-MD5-MODP1024
000 "telco": ESP algorithms wanted: 3DES(3)_000-MD5(1)_000
000 "telco": ESP algorithms loaded: 3DES(3)_000-MD5(1)_000
000 "telco": ESP algorithm newest: 3DES_000-HMAC_MD5; pfsgroup=<N/A>
000 #2: "telco":500 STATE_QUICK_I2 (sent QI2, IPsec SA established); EVENT_SA_REPLACE in 2837s; newest IPSEC; eroute owner; isakmp#1; idle; import:admin initiate
000 #2: "telco" [email protected] [email protected] [email protected] [email protected] ref=0 refhim=4294901761 Traffic: ESPout=0B ESPin=0B! ESPmax=4194303B
000 #1: "telco":500 STATE_MAIN_I4 (ISAKMP SA established); EVENT_SA_REPLACE in 85396s; newest ISAKMP; nodpd; idle; import:admin initiate
política xfrm do ip
src 192.168.16.116/32 dst 192.100.86.0/24
dir out priority 2088 ptype main
tmpl src 192.168.16.73 dst 203.92.y.y
proto esp reqid 16397 mode tunnel
src 192.100.86.0/24 dst 192.168.16.116/32
dir fwd priority 2088 ptype main
tmpl src 203.92.y.y dst 192.168.16.73
proto esp reqid 16397 mode tunnel
src 192.100.86.0/24 dst 192.168.16.116/32
dir in priority 2088 ptype main
tmpl src 203.92.y.y dst 192.168.16.73
proto esp reqid 16397 mode tunnel
cat /etc/ipsec.conf
config setup
protostack=netkey
plutodebug=all
plutostderrlog=/var/log/pluto.log
dumpdir=/var/run/pluto/
nat_traversal=yes
virtual_private=%v4:10.0.0.0/8,%v4:192.168.0.0/16,%v4:172.16.0.0/12,%v4:25.0.0.0/8,%v4:100.64.0.0/10,%v6:fd00::/8,%v6:fe80::/10
# Add connections here
conn telco
type=tunnel
pfs=no
forceencaps=yes
# auto=start
#gx#
left=%defaultroute
leftid=52.76.x.x
leftnexthop=%defaultroute
leftsubnet=192.168.16.116/32
leftsourceip=192.168.16.116
#telco
right=203.92.y.y
rightid=203.92.y.y
# rightnexthop=%defaultroute
rightsubnet=192.100.86.0/24
# rightsourceip=192.100.86.203
#phase 1 encryption-integrity-DiffieHellman
keyexchange=ike
ike=3des-md5-modp1024
ikelifetime=86400s
authby=secret #use presharedkey
rekey=yes #should we rekey when key lifetime is about to expire
#phase 2 encryption-pfsgroup
phase2=esp #esp for encryption | ah for authentication only
phase2alg=3des-md5
keylife=3600s
include /etc/ipsec.d/*.conf
route -n
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.16.1 0.0.0.0 UG 0 0 0 eth0
192.100.86.0 192.168.16.1 255.255.255.0 UG 0 0 0 eth0
192.168.16.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
cat /etc/sysctl.conf
net.ipv4.ip_forward=1
#
net.ipv4.conf.all.rp_filter=0
net.ipv4.conf.default.rp_filter=0
net.ipv4.conf.eth0.rp_filter=0
net.ipv4.conf.lo.rp_filter=0
#
net.ipv4.conf.all.send_redirects=0
net.ipv4.conf.default.send_redirects=0
net.ipv4.conf.eth0.send_redirects=0
net.ipv4.conf.lo.send_redirects=0
#
net.ipv4.conf.all.accept_redirects=0
net.ipv4.conf.default.accept_redirects=0
net.ipv4.conf.eth0.accept_redirects=0
net.ipv4.conf.lo.accept_redirects=0
#
net.ipv4.conf.default.accept_source_route=0
net.ipv6.conf.all.disable_ipv6=1
net.ipv6.conf.default.disable_ipv6=1
net.ipv4.conf.default.log_martians=0
net.ipv4.conf.all.log_martians=0
net.ipv4.icmp_ignore_bogus_error_responses=1