Aqui está a parte do resultado -PDList -a0:
Enclosure Device ID: 252
Slot Number: 4
Drive's position: DiskGroup: 0, Span: 0, Arm: 0
Enclosure position: N/A
Device Id: 12
Sequence Number: 3
Media Error Count: 0
Other Error Count: 0
Predictive Failure Count: 0
Last Predictive Failure Event Seq Number: 0
PD Type: SATA
Raw Size: 931.512 GB [0x74706db0 Sectors]
Non Coerced Size: 931.012 GB [0x74606db0 Sectors]
Coerced Size: 931.0 GB [0x74600000 Sectors]
Sector Size: 0
Firmware state: Failed
Commissioned Spare : No
Emergency Spare : No
Device Firmware Level: A750
Shield Counter: 0
Successful diagnostics completion on : N/A
SAS Address(0): 0x4433221104000000
Connected Port Number: 0(path0)
Inquiry Data: DT01ACA100 MS2OA750
FDE Capable: Not Capable
FDE Enable: Disable
Secured: Unsecured
Locked: Unlocked
Needs EKM Attention: No
Foreign State: None
Device Speed: 6.0Gb/s
Link Speed: 6.0Gb/s
Media Type: Hard Disk Device
Drive: Not Certified
Drive Temperature : N/A
PI Eligibility: No
Drive is formatted for PI information: No
PI: No PI
Drive's NCQ setting : N/A
Port-0 :
Port status: Active
Port's Linkspeed: 6.0Gb/s
Drive has flagged a S.M.A.R.T alert : No
Atualmente estou usando o LSI 9260-8i e ele ficou bem quando tentei configurar o RAID 10, mas depois da reinicialização, o som do bipe começou na placa RAID e o MegaCli mostra "Estado do firmware: falha". O mais estranho é que toda Contagem de Erros é zero, mas falhou. Eu atualizei o firmware da placa RAID, mas nada mudou.
Ou isso é apenas quebrado desde o começo?