Velocidade de upload lenta

Question

minha velocidade de upload é muito lenta. Eu tenho 2 placas de rede RTL8111 / 8168/8411. A velocidade de download é boa, mas a velocidade de upload é muito lenta, cerca de 150 mbps. Eu instalei o Windows 7 no sistema en não houve problema em tudo! Voltei para a edição do servidor Ubuntu 15.10. Eu defino as placas em full duplex 1000mbit, Ipv6 não está funcionando. Eu tenho 500/500 de fibra de vidro. Por favor ajude!

ethtool:

Settings for enp1s0f0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Advertised pause frame use: Symmetric Receive-only
        Advertised auto-negotiation: Yes
        Link partner advertised link modes:  10baseT/Half 10baseT/Full
                                             100baseT/Half 100baseT/Full
                                             1000baseT/Half 1000baseT/Full
        Link partner advertised pause frame use: Symmetric Receive-only
        Link partner advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
Cannot get wake-on-lan settings: Operation not permitted
        Current message level: 0x00000033 (51)
                               drv probe ifdown ifup
        Link detected: yes

$ iptables -v -x -n -L
Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

 iptables -t nat -v -x -n -L
Chain PREROUTING (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

Chain POSTROUTING (policy ACCEPT 0 packets, 0 bytes)
    pkts      bytes target     prot opt in     out     source               destination

$ ethtool -i enp1s0f0
driver: r8169
version: 2.3LK-NAPI
firmware-version:
bus-info: 0000:01:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: yes
supports-priv-flags: no

Eu tenho os drivers precisos para as placas de rede.

    

Answer 1

Instale outro driver para esta placa Ethernet. Executar

sudo apt-get install r8168-dkms

e reinicie.